BLUE AND BLACK PROSTARS BACK IN STOCK

Blue and black prostars are on their way...black available up to size 11 and blue available to size 9.5!!! Complete skates only! No boot only options available. These come with the prodigy plate...fiberglass reinforced nylon. These skates are for all uses!! They are fully heat moldable! Sizes are not in mens or womens sizing so refer to the sizing chart or message us with your measurements in mm. The sizes may be several sizes smaller than your actual shoe size. This is normal.

FIND YOUR SIZE

MEASURE YOUR FEET

Skate boots are not like your average shoe. For maximum control, your boots need to fit like a second skin. That is why Bont boot sizing is NOT the same as your US shoe size or other skate brand sizing.

Wear the type of socks you’ll wear with your boots. Distribute weight evenly before measuring.

STEP 1 On a hard surface, tape a piece of blank paper to the floor. Stand up straight with your foot on the paper. Your heel should be barely touching the wall or not at all. DO NOT push heel into the wall as it will produce incorrect length measurements. STEP 2 Mark the longest part of your foot (heel-to-toe length) and widest part of your foot on the paper with a pen or pencil. If your heel is away from the wall trace around your whole foot. Make sure your pen is held vertically, not at an angle. Repeat with the other foot, as the right and left foot may be different sizes. STEP 3 Use a ruler to measure the heel-to-toe length and width measurement for each foot. Take these measurements and input them into the size calculator or compare them to the size chart below.